Underwriters Laboratories DS-2CD2132-I Manuel d'instructions télécharger pdf (Page 14)

Network Dome Camera·Quick Operation Guide

If required, you can route cables through the side outlet on the

mounting base (as shown in Figure 2-4).

4. Loosen the tilt lock screws, adjust the tilting position in a range

of 65 degrees, and tighten the tilt lock screws.

5. Rotate the black liner to adjust the panning position in a range of

180 degrees until you get the desired surveillance angle.

Surveillance Angle Adjustment Figure 2-4

As the lens has already been factory adjusted to the best imaging

effect, you just need to adjust the panning position and tilting

position to get the desired surveillance angle.

6. Reinstall the bubble and tighten the screws.

Side Outlet

Tilting Adjust

Screw

0°~360°

0°~65°

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Pas de commentaire

Underwriters Laboratories DS-2CD2132-I Manuel d'instructions Page 14