Underwriters Laboratories DS-2CD2232-I5 Manuel d'utilisateur télécharger pdf (Page 59)

User Manual of Network Camera

You can configure the camera to trigger the alarm when the lens is covered and take

alarm response action.

Steps:

1. Enter the Tamper-proof Settings interface:

Configuration > Advanced Configuration > Events > Tamper-proof

Figure 6-28 Tamper-proof Alarm

2. Check Enable Tamper-proof checkbox to enable the tamper-proof detection.

3. Set the tamper-proof area; refer to Step 1 Set the Motion Detection Area in

Section 6.6.1.

4. Click to edit the arming schedule for tamper-proof. The arming

schedule configuration is the same as the setting of the arming schedule for motion

detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in Section

6.6.1.

5. Check the checkbox to select the linkage method taken for the tamper-proof.

Audible warning, notify surveillance center, send email and trigger alarm output are

selectable. Please refer to Step 3 Set the Alarm Actions for Motion Detection in

Section 6.6.1.

6. Click to save the settings.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 94 95

Pas de commentaire

Underwriters Laboratories DS-2CD2232-I5 Manuel d'utilisateur Page 59